Vaughan Scissor Lift Certification

Vaughan Scissor Lift Certification - Many worksites and tradespeople like masons, iron workers and welders use scissor lift platforms to be able to help them reach elevated work places. The utilization of a scissor lift is usually secondary to their trade. Hence, it is important that all operators of these platforms be trained properly and certified. Industry, lift manufacturers and regulators work together to be able to ensure that operators are trained in the safe use of work platforms.

Scissor lift work platforms are likewise called manlifts or AWPs. These work machinery are quite easy to operate and offer a stable work setting, then again they do have risks because they lift people to heights. The following are some key safety concerns common to AWPs:

There is a minimum safe approach distance (also known as MSAD) for all platforms in order to protect from accidental power discharge because of proximity to wires and power lines. Voltage can arc across the air and cause injury to employees on a work platform if MSAD is not observed.

In order to ensure maximum steadiness, care must be taken when the work platform is lowered. When you move the load towards the turntable, the boom must be retracted. This would help maintain steadiness in lowering of the platform.

Regulations do not mandate people working on a scissor lift to tie off. Nevertheless, employees may be required to tie off if required by employer rules, job-specific risk assessments or local regulations. The manufacturer-provided anchorage is the only safe anchorage wherein lanyard and harness combinations should be attached.

It is important to observe and not go beyond the maximum slope rating. The grade could be measured by laying a board on the slope or by laying a straight edge. A carpenter's level can then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, you can determine the percent slope.

In order to determine whether the unit is mechanically safe, a typical walk-around check should be carried out. Work site assessments are likewise essential to make certain that the work area is safe. This is vital specially on changing construction sites due to the possibility of obstacles, unimproved surfaces, and contact with power lines. A function test must be performed. If the unit is utilized properly and safely and proper shutdown measures are followed, the chances of incident are greatly lessened.

Click to Download the pdf