Vaughan Boom Lift Safety Training

Vaughan Boom Lift Safey Training - Boom lifts are a type of elevated work platform or aerial lifting device which are commonly used in construction, industry, and warehousing. Boom lifts could be made use of in virtually whichever environment due to their versatility.

Elevated work platforms allow workers to access work areas which will be unreachable otherwise. There is inherent danger in the operation of these devices. Workers who operate them have to be trained in the right operating methods. Preventing accidents is vital.

The safety aspects which are included in boom lift operation are included in our Boom Lift Training Programs. The course is suitable for people who operate self-propelled boom supported elevated work platforms and self-propelled elevated work platforms. Upon successful completion of the course, participants would be given a certificate by an individual who is qualified to confirm the completion of a hands-on evaluation.

To help train operators in the safe utilization of elevated work platforms, industry agencies, local and federal regulators, and lift manufacturers all play a part in establishing standards and providing the necessary information. The most essential ways in preventing accidents connected to the use of elevated work platforms are as follows: conducting site assessments; inspecting machines; and putting on safety gear.

Key safety factors when operating Boom lifts:
Operators have to observe the minimum safe approach distance (MSAD) from power lines. Voltage can arc across the air to find an easy path to ground.

To be able to maintain stability when the platform nears the ground, a telescopic boom should be retracted before lowering a work platform.

People working from the Boom lift platform should tie off so as to ensure their safety. Safety harness and lanyard combinations should not be connected to any anchorage other than that provided by the manufacturer, never to other wires or poles. Tying off may or may not be necessary in scissor lifts, depending on particular local rules, employer guidelines or job risks.

Avoid working on a slope that exceeds the maximum slope rating as specified by the manufacturer. If the slop exceeds requirements, then the equipment should be transported or winched over the slope. A grade can be simply measured by laying a minimum 3-feet long straight edge or board on the slope. After that a carpenter's level could be laid on the straight edge and raising the end until it is level. The per-cent slope is attained by measuring the distance to the ground (also known as the rise) and dividing the rise by the length of the straight edge. Then multiply by 100.

Click to Download the pdf